![]() ![]() It should find your NAS with the IP address we set up in step 2. If you have a Mac, please refer to this guide.ģ.Run Qfinder on your computer. If you’re running Windows, please read the instructions here. You may use any of the available LAN port on the NAS.Ģ.Set your PC/Mac to IP address 169.254.100.99 and submask 255.255.0.0 In this case, you should do the same for your PC, and configure it for DHCP.ĭiscover your NAS Through the Qfinder Pro discovery toolĭownload the software from QNAP website, and you should be able to find it.ġ.Connect the NAS to your PC/Mac with a direct ethernet cable. If the NAS is “Out of the box” new, then it should be configured for DHCP, meaning it would be given a default address if you connect it directly to your PC. Make sure that the 2 devices are in the same IP subnet. Without my involving a 10Gbe switch such as the NETGEAR 5-port 10Gig Gigabit Ethernet Unmanaged Can the 10Gbe port of the iMac Pro be connected directly to the TS-453BT3-8G Internal cloud uninvolved with the Internet, and that at least the T3’s and 10Gbe would be atġ0Gbe-ish speeds. I purchased the TS-453BT3-8G with the thought that I could use its 2x T3 ports, 1xġ0Gbe, and 2x 1Gbe to connect multiple computers to its stored data–and to each other–in an ![]() I’m a NAS Newbie, and not NetworkĬompetent. “ I have done direct connection test, NAS can be seen in Network Neighborhood when directly connected.Please pardon my ignorance and thank you for your helpfulness. “ I’m running direct connection test, but I can’t see the NAS in Network Neighborhood ”Ĥ.2 If you can see the NAS in direct connection test,but not able to see the NAS after putting the NAS back to original network.Ĥ.2.1 Please try enable Local Master Browser by this guideĤ.2.2 If enabling Local Master Browser doesn’t work, please help to open a ticket by QNAP Service Portal ![]() Please help to open a ticket by QNAP Service Portal This method could be used to rule out any network variable that might be interfering with the visibility of your NAS.ģ.On Windows, please find File Explorer > Network ,check if the NAS is in the Computer list.Ĥ.1 If you can ping the NAS and reach QTS web interface by NAS self-assigned IP in direct connection test,but not able to see the NAS in Network Neighborhood ( File explorer > Network). Secured login and multi-factor authenticationġ.On NAS, please check Server name of your NAS by Control Panel > System > General Settings > System Administration,Ģ.Please set up the following direct connection test environment described in the link.Support Milestone Surveillance Platform.NAS Smart Surveillance System Solutions.NDR Solutions against Targeted Ransomware.Software-defined Platform Total Solution.Support Platform9’s Managed OpenStack Solution.Veeam-Ready and Virtualization Certifications.Management center for device and user permission.With Linux and ZFS, QuTS hero supports advanced data reduction technologies for further driving down costs and increasing reliablility of SSD (all-flash) storage. QuTS hero is the operating system for high-end and enterprise QNAP NAS models. WIth Linux and ext4, QTS enables reliable storage for everyone with versatile value-added features and apps, such as snapshots, Plex media servers, and easy access of your personal cloud. ![]() QTS is the operating system for entry- and mid-level QNAP NAS. ![]()
0 Comments
Leave a Reply. |